OXEVAC

OUR STORY

Oxevac was created after 30 years of servicing dental vacuum lines, observing that
other cleaners were not properly cleaning and sanitizing. One of my fellow
technician's and I took it upon ourselves to explore other options as we knew how
costly this problem was to dentist. After 10 years of laboratory testing and in office
testing, we now have a patent pending product that actually works with all
evacuation pumps, and is environmentally friendly. I know there are other products
on the market that smell good and say they work, but as a service technician who
fights the battles in the trenches everyday, I can assure you there is a clear
distinction between smelling good and actually cleaning the lines / vacuums pumps.
Oxevac is a cleaner that when used on a everyday basis in a dental office will
continuous clean the dental lines and vacuum pump. The efficiency of the pumps
and the clean lines will insure that the office will not have evacuation problems in
the dental office, and allow the dentist to have less service calls on his vacuum
system.

- GENE GANT , INVENTOR

 

HIGHLIGHTS

• Oxevac’s powerful peptizing fizzing action begins cleaning immediately, clearing evacuation lines of any build up, residue, and odor

• Sanitizing continues even when your pump is turned off, and continuous usage ensures a clean evacuation system

• Made in the USA (Patent Pending )

• Environmentally friendly, and safe for all vacuum pumps

• Each case contains 24 individual 3.6 ounce packets

• To use, simply mix one packet with one gallon of hot water

• Non Foaming and A Neutral PH

• Does not dissolve Amalgam

COMPATIBILITY TESTING

Typical Vacuum Pump parts were used as shown below. The parts were soaked in a typical solution, 1 packet (3.6oz) of Oxevac : 1 gallon of warm water, for 24 hours. All parts were photographed and measured using a micrometer before and after testing. None of the parts showed a visual or measurable change.

  • STAINLESS STEEL
  • COPPER
  • ALUMINUM
  • BRASS
  • NEOPRENE O-RINGS

HOW TO USE OXEVAC

  1. Mix one package into a gallon bucket with hot water
  2. Start at the furthest room from the vacuum pump
  3. Vacuum up through the SAI ejector and HVE about 32oz per room
  4. Check chair traps after each treatment
  5. Check trap at vacuum pump after treatment of all rooms
  6. This should be done at the end of each day to assure the vacuum lines are cleared